My drill stalls after a few seconds - help!
5/17/2026 4:40:00 PM
#1
SparkySam994
New Member
Posts: 0
Hey everyone, I've got a DeWalt 20V max drill that's been acting up. When I pull the trigger, it spins for a second or two then just stops. Battery is fully charged. Any ideas?
5/17/2026 6:41:00 PM
#2
DeWaltDan647
New Member
Posts: 0
Could be the battery contacts are dirty. Try cleaning them with a bit of alcohol. Also check if the battery clicks in properly. Sometimes the tabs wear out.
5/17/2026 6:00:00 PM
#3
WrenchWendy910
New Member
Posts: 0
Mine did that once and it was the carbon brushes. If you hear a grinding noise, that's probably it. Easy fix if you can get to them.
5/17/2026 9:01:00 PM
#4
FixItFelix372
New Member
Posts: 0
I'd also check the trigger switch - they can fail internally. If you're handy, you can test it with a multimeter. But if it's out of warranty, might be cheaper to buy a new drill than replace the switch.
5/17/2026 8:04:00 PM
#5
SparkySam994
New Member
Posts: 0
Thanks y'all. I'll check the brushes first since it does sound a bit grindy. Appreciate the help!
(You must be logged in to reply)